Changing the value of R L will affect the amplification of the output wave.Ī transistor is normally a current amplifier, meaning the current flowing though the base will be amplified in the current flowing through the collector. The Resistor R1 is the load resistor and the resistor R2 is the emitter resistor. In the above circuit the resistors R3 and R4 form a potential divider which decides the Emitter -Base voltage (V BE). Here the input sine wave of magnitude 8mV (yellow colour) is amplified to 50mV (Pink colour) as shown in the graph. The simulation graph that shows the amplified output sine wave can also be found. A very simple bare minimum circuit for a transistor to work as an amplifier is shown below. So if you are looking for an NPN transistor for you amplifier circuit, then this transistor might be the right choice.Īs told earlier the 2N5551 NPN transistor is widely used for amplification. It also has decent switching characteristics (Transition frequency is 100MHz) hence can amplify low-level signals.ĭue to this feature, the transistor is commonly used for amplification of audio or other low power signals. The 2N5551 is an NPN amplifier Transistor with an amplification factor (hfe) of 80 when the collector current is 10mA.

Collector-Emitter voltage (VCE) is 160 V.Continuous Collector current (IC) is 600mA.

High DC Current Gain (hFE), typically 80 when IC=10mA.

Current Drains out through emitter, normally connected to groundĬontrols the biasing of transistor, Used to turn ON or OFF the transistorĬurrent flows in through collector, normally connected to load

Kegunaan transistor 2n 5551